Rimon: com uoi. oim kahon (( om im i:d), N: c, Uoi. o – Philips MX2797B User Manual

Page 31

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

imo

n: C

uoi. O

kahon

((

)

A D D K I ( ’ ( i m f ’ u o i . K

< ) 1

Ki \ i ( M I

For most homes this step would

not be needed but for your
information:

Up to 9 different remote locator

address codes can be set on which the

TV can send out its "homing" signal.

This is done in case there is more than

one TV (with a remote locator)

present, and you want only one

specific remote to be signaled when the
TV is turned ON,*

To set a Locator Address Code;

CBBOIWJ

With TV turned ON, press the

LOCATOR CODE button on the
remote. (Also be sure the TV
SYSTEM button on the remote has
been pressed.)

You will need a pencil or pen to press
the recessed button.

The TV shows the present Remote
Locator Code.

Press any number button (0-9) on

the remote to set or change the

Locator Code.

See the above information on
how to use the Locator Còde
Button for Programming^

S M A R I

lil

i l >

Remember, if batteries are

replaced the Locator Code

will need to be reentered.

When setting the Locator Code if any
button, odier than the number buttons,
are pressed the remote will return to
its normal operation mode.

♦For owners who live in an apartment
(townhouse or condominium)

complex, this task may be necessary
since the remote locator's signal can
be sent and detected directly through
adjoining walls.