Si:n in(i yoi u rimo ri: to w, Si:\rc n – Philips MX2797B User Manual
Page 40
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Si:n iN(i Yoi u RiMo ri: To W
ork
VCR
s
, C
onvi
:
ri
i
:
rs
- Si:\Rc n
y
'our TV remote can be set to
work your VCR or Cable
Converter by what is called the
SEARCH method.
If the "REMOTE CODE” number
method shown in the previous
section did not set your remote to
work your VCR or Converter, then
follow the easy steps listed below.
Please read through steps 1-4
before beginning.
imam)
Press the POWER button on
the VCR or Converter to turn the
I unit ON.
from the front of the VCR or
Converter.
Point the remote toward the unit
HOLD DOWN the SURF and
the desired System (VCR or
CBL-Converter) buttons at the
same time. KEEP HOLDING
BUTTONS DOWN.
Watch the Channel Indicator
on the unit
Channel Numbers will SCAN UP
when the unit has been identified.
This may take up to two minutes.
<^3^ Release the SURF and System
(VCR or CBL) buttons as soon
as channel numbers start to scan
up. The code has been identified
and the remote is ready to operate
with the VCR or Converter.
S \ i V K i I I I
Remember, a minute or
two can seem very long, but
the code should be located within
two minutes.
Don't let the VCR or Converter
scan up more than five channels.
The remote may pass up the right
code and another two minute
search cycle will have to be
repeated.
If no channel change happens
within two minutes, repeat steps 1-
4. Should a channel change still
not occur, the remote will not
work with the desired unit.
CABLE CONVERTER
40