beautypg.com

Recording, Cd synchro start recording, Recording the mixed sound / one touch recording – Philips FW890P37 User Manual

Page 27: Digital recording via digital out

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

I

RECORDING

Dubbing tapes

(from tape deck 1 to

tape deck 2)

1 Press TAPE (TAPE 1*2 ) to select tape

deck 2.

2

Load the prerecorded tape into tape

deck 1 and a blank tape into tape deck

2

.

-* Make sure the tape in tape deck 1

has its full spool to the left.

3 (For Tape Deck 2 only)

Press

SIDE on the remote control to

select the recording side.

4 Press DUB (HSD) o/icefor normal

speed dubbing or twice (within 2

secondsj for high speed dubbing.

-* liORnFiL" (normal speed) or

"F'

h

ST" (high speed) will be

displayed, followed by

"DuBBIrib".

— The

HSD

flag appears on the display

during high speed dubbing.

• Dubbing will start immediately.

The

REC

flag starts flashing.

5 Press to stop dubbing.

Notes:

- At the end of side A, flip the tapes to

side B and repeat the procedure.

- Dubbing of tapes is only possible from

tape deck i to tape deck 2.

- To ensure good dubbing, use tapes of

the same length.

- During high speed dubbing in Tape

mode, the sound is reduced to a low

volume.

- You can listen to another source while

dubbing.

CD Synchro Start Recording

1

Load a blank tape into tape deck 2 and a

disc into a disc tray.

2 Press CD to select CD mode.

• You can program the tracks in the order

you want them to be recorded (see

Programming Tracks). If you do not, the

tracks are recorded according to the

order on the selected disc.

3 Press REC to start recording.

The

REC

flag starts flashing.

• CD will start playback automatically.

4 Press ■ to stop recording.

Recording the mixed sound /

One Touch Recording

• During microphone mixing, you can

record the mixed sound on a tape in

tape deck 2 except dubbing mode.

• For One Touch Recording, as soon as you

press

REC, the current source (CD,

TUNER or AUX) will be recorded on tape

deck 2

1 Load a blank tape in tape deck 2.

2 Press REC to start recording.

— The REC flag starts flashing.

3 Press ■ to stop recording.

Note:

- When you press RECORD while in TAPE

mode, '5EL.ECT SOURCE'' will be

displayed. Dne Touch Recording is not

possible in TAPE mode.

Digital Recording via Digital

Out

For CD digital recording, please refer to the

Instructions Manual of the CD Recorder,

digital audio equipment, etc.

27