Winco Mfg. 8450SH - Multi-Task Table with Shelf - Manual (Page 2)

Page 2 of 4
006145 Rev.T Date 06-06-12 JWC
Brace Installation for 8400-8450:
1. Place (4) ¼-20 x 1-½” carriage bolts in (4) holes through the lower brace of the Table Legs.
2. Align
the Cross-brace (smooth, un-welded side, facing table bottom) with the (4) screws & holes on both
Table Legs and fasten with (4) ¼-20 nuts. Tighten these (4) screws.
NOTE: For table without shelf; nylon inserts on brace should face toward bottom of table.
3. 8450 ONLY: TIGHTEN ALL nuts & bolts at this time.
4. Using at least two people, turn table upright.
5. 8450 ONLY: Install Paper Holder and paper by inserting it through the Paper Rod Holders on the ends of
Table Frame Rails.
6. Adjust the (4) Glide Feet to level table.
Optional Shelf installation for 8400-8450:
1. Double-sided tape has been installed on the Cross-brace.
2. Before removing paper on tape, “test fit” the shelf. Shelf should be centered on Welded Brace Assembly.
3. Once you are certain of where you will position the shelf, peel off the paper to expose adhesive.
4. Carefully position shelf in place on adhesive.
ADDITIONAL INSTRUCTIONS for 840 PEDIATRIC TABLE ONLY:
Rear Pediatric Retainer Installation:
1. With table laying on one long side (be sure to protect vinyl); remove the (4) four ¼-20 x 3” screws & (4)
¼ - 1” washers from the Table Frame Rail.
NOTE: The 3” screws are left loose intentionally, so you can identify them easier.
2. Place the screws & washers (you just removed) through the brackets on the Rear Pediatric Retainer, then
through the Table Frame Rail, and finally back into the threaded holes in the table top.
The washers should be positioned between the bracket and the Table Frame Rail.
TIP: Start one screw and allow it to hold the retainer while you start the other screws.)
3. Once all (4) screws have been installed, tighten them.
Side Pediatric Retainers Installation:
1. Next, install (3) ¼-20 x 1-¾” bolts (hex-head) through the (3) brackets on the Side Pediatric Retainers, then
through (3) Nylon Spacers, and finally into the threaded holes in the table top.
TIP: Thread all bolts in by hand before fully tightening them.
2. TIGHTEN ALL nuts & bolts at this time.
Vinyl Strap Adjustment – 8450 Only - Should the vinyl strap on your Winco table need to be adjusted, unscrew the
screw that currently holds either side of it in place. Pierce another hole in the strap to give desired tension and re-
insert screw.
Wrinkles in Vinyl – Storage and shipping can cause wrinkles of the vinyl on your Winco table. This is normal.
Please allow 1-2 weeks at room temperature (approx. 70+ degrees) to allow for vinyl to expand back to original
appearance.
After peeling paper from adhesive tape:
Use damp sponge to moisten tape to allow shelf to be adjusted during install.
Once tape is dry shelf will stay in place.
Do not over tighten nuts and bolts. Periodically recheck all
fasteners for tightness.