Winco Mfg. 6990 XL Nocturnal Recliner - Manual (Page 5)

4
ASSEMBLY INSTRUCTIONS
BACK ASSEMBLY INSTRUCTIONS
1. Carefully remove back assembly and chair frame from
carton.
Note: Handle with care when removing chair
from box. This will ensure that no damage is
done to the cables and/or wiring that connects
the back to the chair.
2. Lock ALL (3) total-lock casters on chair base. (see Lock/
Unlock Casters page 6).
NOTE: Make sure the footrest is in closed position
before installing the back.
3. Cut the "zip-tie notice tag" on the back
mechanism fork, located behind the seat.
4. Pull UP on the back adjustment handle (FIG.2A) to
bring the back mechanism (FIG.2B) into its upright
position.
5. Using 2 people (RECOMMENDED), have one person grab
the Push Handle on the back, and hold the back in
position over mounting forks. Align the forks on base
(FIG. 3A) with the guides on back (FIG. 3B).
6. Slide the guides onto the mounting forks until the guides
"SNAP" or click into their proper location.
(Circled, FIG.3A).
7. Once the back has been tested for proper installation,
close the "hook & loop" flaps.
FIG. 1
FIG. 3A FIG. 3A
FIG. 3B FIG. 3B
FIG. 2
FIG. 3
Test to ensure the back has been properly installed by pulling up on
the back's push handle.
The back should remain securely in place
REGULARLY lubricate pivot points on the Recline Mechanism with a silicone based lubricant.
Once per week, position the Chair Back into full recline position, squeeze release handle and go to full Trendelenburg
position. This will keep the gas cylinder lubricated.
Periodically recheck tightness of all screws, bolts and nuts.
IMPORTANT
IMPORTANT