Winco Mfg. 5560 - Comfort Care Premier Recliner - Manual (Page 2)

Page 2 of 3
006110 Revision N Date 01-28-11 JWC
6. Insert (2) two Bow Tie Cotter Pins, into the small holes on ends of the (2) two Clevis Pins you just installed.
7. Remove the Bow Tie Cotter Pin and the Clevis Pin from the Back Support Strut (attached to backframe).
8. Align the holes of the Back Support Strut with the holes in the Angle Brackets (on chair frame) and insert
the Clevis Pin into these aligned holes and secure with the Bow Tie Cotter Pin.
Operation of the Chair:
9. NON-RESTRAINT: To make the chair permanently non-restraint, remove the Snap Button of the Right Tray
Arm, and unbolt the Position Lock Bar from the back of the chair.
10. This recliner has three (3) positions; UPRIGHT, SEMI-RECLINE, and RECLINE, which can be achieved by
user or attendant. The position lock bar can only be engaged or disengaged by attendant. Not all notches on
Position Lock Bar are used for this model chair.
11. POSITION LOCK: Attendant may hold the chair in a reclined position by engaging the Position Lock. To
safely accomplish this, recline the chair to the 2
nd
or 3
rd
recline position and lower the position lock with your
hand until the notches on the Position Lock bars engage with the Position Lock Pins.
To release Position Lock, raise the Position Lock off of the Pins and return chair to upright position.
12. This chair is equipped with Total Lock casters. Stepping on the brake tab will lock the wheel and the swivel
mechanism of the caster for added safety and security.
To ensure proper operation of the reclining mechanism, lubricate all pivot points with a silicone type lubricant (or lubricant
approved by your facility) at least twice yearly. Periodically recheck tightness of all screws and bolts.
Wrinkles in Vinyl – Storage and shipping can cause wrinkles of the vinyl on your Winco chair. This is normal. Please allow 1-2
weeks at room temperature (approx. 70 degrees) to allow for vinyl to expand back to original appearance
Failure to correctly install clevis pins connecting Back Frame fork holes and
Seat Frame Rail holes, will cause back to operate poorly and may cause injury
to the user or damage the chair and void warranty.
WARNING: Attendant must release Position Lock before patient can exit chair – If patient attempts to
exit chair with Position Lock engaged, SERIOUS INJURY MAY RESULT.
WARNING: Failure to release the Position Lock before changing positions will result in damage to the
chair and void the warranty.
Periodically recheck tightness of all screws and bolts, and never use the chair arms, backrest, legrest or
tray as a seat.