Winco Mfg. 8550SH - Recovery Couch with Shelf - Manual (Page 2)

Page 2 of 4
006070 Rev R Date 06-06-12 JWC
6.
TIGHTEN ALL nuts and bolts at this time.
7. Install the four (4) Threaded Inserts with Glide Feet into the ends of the table legs.
8.
Using at least two people, turn table upright.
9. Remove (1) of the white plastic caps on the Paper Rod and install into the (2) Paper Rod Clamps, replace cap.
Adjust (4) 5/16” Glide Feet to level table.
Optional Shelf installation:
10. Double-sided tape has been installed on the Reinforced Cross-brace.
11.
Before removing paper on tape, “test fit” the shelf. Shelf should be approximately ¼” from edge of the
Lower Leg Brace of the Table Legs.
12. Once you are certain of where you will position the shelf, peel off the paper to expose adhesive.
13.
Carefully position shelf in place on adhesive.
Vinyl Strap Adjustment – Should the vinyl strap on your Winco table need to be adjusted, unscrew the screw that
currently holds either side of it in place. Pierce another hole in the strap to give desired tension and re-insert screw.
Wrinkles in Vinyl – Storage and shipping can cause wrinkles of the vinyl on your Winco table. This is normal. Please
allow 1-2 weeks at room temperature (approx. 70 degrees) to allow for vinyl to expand back to original appearance.
If the Optional Shelf and Reinforced Cross-brace have been ordered; make sure that the smooth surface (side with
tape) of the Cross-brace will face upward (when the table is in the upright position) prior to fastening to Table Legs.
After peeling paper from adhesive tape:
Use damp sponge to moisten tape to allow shelf to be adjusted during install.
Once tape is dry shelf will stay in place.
Do not over tighten nuts and bolts. Periodically check all fasteners for tightness.