Viconics VT7200 Installation Manual (Current Release 5000 Series PIR Ready) - Manual (Page 10)

10 | PIR Ready VT7200 Series-Installation Guide
Pressure dependent VAV cooling / heating with changeover and reheat:
VT7200C5x00(x) Floating actuator
Mandatory

Out1Conf = 2.0

CntrltTyp = Floating

FL time = as per
actuator
If heat / cool auto-
changeover with a local
discharge air
temperature sensor set:

SeqOpera = 2
Cooling with Reheat

UI3 = COS
Pressure dependent VAV cooling / heating with changeover and reheat:
VT7200F5x00(x) Analog actuator
Mandatory

Out1Conf = 2.0

RA/DA = as per
actuator
If heat / cool auto-
changeover with a local
discharge air
temperature sensor set:

SeqOpera = 2
Cooling with Reheat

UI3 = COS
Supply air
temperature sensor
1 C
UI3 COS
0 V~ Com
24 V~ Hot
BO1 Open
BO2 Close
BO5-Aux
BO5-Aux
Sensor
Room Temperature Control
& Maximum Position
Adjusted on the actuator
Modulating Floating
VAV Actuator
Heating and/or Cooling
& On/Off Duct Heater
Minimum
Sensor
Analog VAV Actuator
Heating and/or Cooling
& On/Off Duct Heater
& Maximum Position
the actuator
Minimum
Adjusted on
Room Temperature Control
Supply air
temperature sensor
1 C
0 to 10
VDC
UI3 COS
0 V~ Com
24 V~ Hot
AO1
BO5-Aux
BO5-Aux
AO2
Changeover
Changeover