Viconics VT7000 Series Application Guide - Manual (Page 27)

27
VI-PIR Cover Installation
•
Remove security screw on the bottom of the current thermostat cover.
•
Open up by pulling on the bottom side of thermostat. (Fig. 3)
A)
Identify current thermostat model type:
•
Use appropriate cover accessory part number as identified on the first page by referring to the thermostat model
number
•
The male polarized PIR connector is located at bottom left corner of thermostat (Fig. 4)
B) Installation:
•
Hinge new PIR thermostat cover into position (fig. 3).
•
Insert polarized connector into PIR female connector located on thermostat base (Fig 4)
•
Snap PIR thermostat cover into place and re-install the security screw
•
Make appropriate parameter settings related to your application within the configuration menu as identified in the
thermostat installation
•
Electronic controls are static sensitive devices. Discharge yourself properly before manipulation and
installing the thermostat and its accessories.
•
Short circuit or wrong wiring may permanently damage the thermostat or the equipment.
•
All VT7000 series thermostats are to be used only as operating controls. Whenever a control failure could
lead to personal injury and/or loss of property, it becomes the responsibility of the user to add safety
devices and/or alarm system to protect against such catastrophic failures.
Specifications
PIR cover power requirements: 5 Vdc Max current draw of 7mA
Operating conditions: 0 °C to 50 °C ( 32 °F to 122 °F )
0% to 95% R.H. non-condensing
Storage conditions: -30 °C to 50 °C ( -22 °F to 122 °F )
0% to 95% R.H. non-condensing
Sensor: Local Passive Infra Red Sensor
Dimensions with Thermostat: 4.94” x 3.38” x 1.13”
Approximate shipping weight with Thermostat: 0.75 lb ( 0.34 kg )
Agency Approvals:
UL UL 873 (US) and CSA C22.2 No. 24 (Canada), File E27734 with CCN
XAPX (US) and XAPX7 (Canada)
FCC Compliant to CFR 47, Part 15, Subpart B, Class A (US)
Industry Canada ICES-003 (Canada)
CE EMC Directive 89/336/EEC (Europe Union)
C-Tick AS/NZS CISPR 22 Compliant (Australia / New Zealand)
Supplier Code Number N10696
Drawing & Dimensions
Thermostat Dimensions
Fig.5
Fig.4
Fig.3