Compaq 110 - Manual (Page 109)

Removal and Replacement Procedures
Maintenance and Service Guide 5–41
5. Remove the M2.5 × 5.5 screw 1 securing the optical drive
alignment rail to the base enclosure (Figure 5-25).
6. Remove the two M2.5 × 5.5 screws 2 securing the system
board to the base enclosure.
7. Remove the optical drive alignment rail 3.
8. Disconnect the microphone cable 4 from the system board.
Figure 5–25: Removing the Interior System Board Screws,
Optical Drive Alignment Rail, and Disconnecting the
Microphone Cable
238850-003.book Page 41 Friday, December 21, 2001 2:53 PM