Compaq 110 - Manual (Page 101)

Removal and Replacement Procedures
Maintenance and Service Guide 5–33
2. Remove the three M2.5 × 5.5 screws 1 securing the hard
drive and hard drive bracket to the base enclosure
(Figure 5-20).
3. Remove the hard drive bracket 2 from the base enclosure.
4. Slide the hard drive toward the front of the base enclosure 3
to disconnect it from the system board.
5. Remove the hard drive from the base enclosure 4.
Figure 5–20: Removing the Hard Drive
Reverse the above procedure to install the hard drive.
238850-003.book Page 33 Friday, December 21, 2001 2:53 PM