Vexilar LC-507 - Manual (Page 9)

9
TROLLING MOTOR MOUNTING
Install the bracket assem-
bly onto the transducers. Set
the two transducers down on
a flat surface, back to back.
Install the bracket assembly
as shown in figure 9. Use the
two included large cable ties
to attach the transducer to the
electric trolling motors lower
unit. Using the slots in the
transducer bracket, run the
ties through them and
around the motors lower
unit. Locate the transducers
on the bottom of the lower unit as in figure 10. Locate the 107 kHz
towards the front of the
motor. This transducer is
more susceptible to noise,
so keep it further away
from the propeller
Run the cables up the
shaft using smaller cable
ties to hold it in position.
Make sure that the cables
will not be damaged by the
movement of the trolling
motor. Plug the transducer
connectors into the back of
the unit and tighten the
retaining rings.
There is an optional one
piece mounting bracket,
part #TMB003. This brack-
et is more compact and
durable than the standard.
Figure 9
Figure 10