VACUUBRAND CVC 2II - Manual (Page 27)

page 27 of 36
Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check
carefully the validity of this document with respect to his product. manual-no.: 997835 / 15/12/2009
Installation and accessories
Components
the VACUUBRAND chemistry vacuum system consists e. g. of the following components:
In combination with VACUUBRAND chemistry diaphragm pumps and additional acces-
sories, the controller can be upgraded to a system which
-
recovers solvents next to 100%.
- allows to operate simultaneously several work stations with one chemistry vacuum
pump by using the components of the VACUU•LAN
® .
- controls pump and cooling water process-orientated.
- allows to adapt the system quickly and cost-efficient to specific requirements thanks
to its modular concept.
Vacuum generation
Chemistry diaphragm pump MD 4C (230 V, 50/60 Hz)
3,0 m
3 /h, 2 mbar ........................................................ 69 62 92
Chemistry diaphragm MZ 2C (230 V, 50/60 Hz)
1,7 m
3 /h, 9 mbar ........................................................ 69 62 41
Pump support kit
(for installation of the diaphragm pump in vertical position)
-
space saving
- avoiding accumulation of condensate in the pump
Pump support MD 4C .............................................. 69 99 24
Pump support MZ 2C .............................................. 69 99 25
Solvent recovery
The exhaust waste vapour condenser enables an easy and
efficient condensation of vapours under atmospheric pressure.
-
catchpot at the inlet prevents condensates form entering
the pump
- exhaust waste vapour condenser for condensation at cool-
ing water temperature and atmospheric pressure at favour-
able thermodynamic conditions
- next to 100% solvent recovery
Upgrade AK + EK for MZ 2C ................................... 69 99 26
(baseplate with catchpot at the inlet and exhaust waste vapour
condenser)