VACUUBRAND VHC Pro - Manual (Page 24)

page 24 of 27
Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check carefully
the validity of this document with respect to his product. 25/11/2013 // 999281
Repair - return - DAkkS calibration
Safety and health of our staff, laws and regulations regarding the handling of dan-
gerous goods, occupational health and safety regulations and regulations regarding
safe disposal of waste require that for all pumps and other products the “Health and
safety clearance form“ must be sent to our office fully completed and signed before
any equipment is shipped to the authorized service center.
Fax or mail a completed copy of the health and safety clearance form to us in ad-
vance. The declaration must arrive before the equipment. Enclose a second com-
pleted copy with the product. If the equipment is contaminated, you must notify
the carrier.
No repair / DAkkS calibration is possible unless the correctly completed form
is returned. Inevitably, there will be a delay in processing the equipment if in-
formation is missing, or if this procedure is not followed.
If the product has come in contact with chemicals, radioactive substances or other
substances dangerous to health or environment, the product must be decontami-
nated prior to sending it back to the service center.
- Return the product to us disassembled and cleaned and accompanied by a
certificate verifying decontamination or
- Contact an industrial cleaning and decontamination service directly.
To expedite repair and to reduce costs, please enclose a detailed description of the
problem and the product’s operating conditions with every product returned for repair.
We submit repair quotations only on request and always at the customer’s ex-
pense. If an order is placed, the costs incurred for problem diagnosis are offset from
the costs for repair or from the purchase price, if the customer prefers to buy a new
product instead of repairing the defective one.
- If you do not wish a repair on the basis of our quotation, the equipment may
be returned to you disassembled and at your expense.
In many cases, the components must be cleaned in the factory prior to repair.
For cleaning we use an environmentally friendly water based process. Unfortunately
the combined attack of elevated temperature, cleaning agent, ultrasonic treatment
and mechanical stress (from pressurised water) may result in damage to the paint.
Please mark in the health and safety clearance form if you wish a repaint at your
expense just in case such a damage should occur.
We will also replace parts for cosmetic reasons at your request and at your expense.
Before returning the equipment ensure that (if applicable):
- Oil sealed pumps: Oil has been drained and an adequate quantity of fresh oil has
been filled in to protect against corrosion. Dispose according to regulations.
- Equipment has been cleaned and/or decontaminated (inside and outside).
- All inlet and outlet ports have been capped.
- Equipment has been properly packed, (if necessary, please order original pack-
aging materials at your costs), marked appropriately and the carrier has been
notified of any possible contamination.
- The completed health and safety declaration is enclosed.
We thank you in advance for your understanding the necessity for these measures
that protect our employees, and ensure that your device is protected in shipment.
Scrapping and waste disposal:
Dispose of the equipment and any components removed from it safely in accord-
ance with all local and national safety and environmental requirements. Particular
care must be taken with components and waste oil which have been contaminated
with dangerous substances from your processes. Do not incinerate fluoroelastomer
seals and O-rings.
- You may authorize us to dispose of the equipment at your expense.
Notes on return to the factory
NOTICE
NOTICE