USL JSDV-100 - Manual (Page 2)

JSDV-100 Installation Instructions
April 26, 2011
Revised May 11, 2011
Page 2 of 3
Update through a Web Browser
Type in the IP address of the JSD-100 into the URL field of a web browser. From the JSD-100 home page, click on
“Configuration Page”. The JSD-100 will require a username and password. The username is “admin” and the
default password is “ultra”. On the configuration page, click on “Update Firmware Page”. The current firmware
versions are shown within the buttons on the page. If these need updating, select the appropriate file from the CD
that was shipped with the JSDV-100 and then press the corresponding button. During the download, the front
panel LEDs on the JSD-100 will flash. After a download of the PIC, the JSD-100 will reset to start executing the new
code. The browser will disconnect at that time.
Installation
1. Mount the supplied electrical box at the desired JSDV-100 location/s.
2. Run a CAT5 cable from the JSD-100 to the JSDV-100 location/s, daisy chaining as described above.
3. Install the supplied RJ-25 connectors at each end of the cable. Cut off the brown-white/brown pair since it
is not used. The pins should get the wire colors indicated below:
1 white/green
2 white/orange
3 blue
4 white/blue
5 orange
6 green