Uncle Milton Fire and Ice Prehistoric Volcano - Manual (Page 2)

Cleaning Fire (Earth) Volcano
DO NOT wash parts in dishwasher.
Carefully hand rinse the volcano
base avoiding excess water around
the ON/OFF switch and battery
compartment. Towel dry.
After each experiment, rinse the
volcano and run water down into
the central vent of the volcano to
clear away remaining eruption
ingredients.
Ice Volcano
To create another eruption, quickly
rinse the central vent of the volcano
with COLD water to clear away
remaining eruption ingredients.
MANUFACTURED BY UNCLE MILTON INDUSTRIES, INC.
P.O. Box 6281, THOUSAND OAKS, CA 91359 USA
©2014 UMI. All rights reserved. ® and TM designate trademarks of Uncle Milton Industries, Inc.
MADE IN CHINA
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE — DO NOT DISCARD
Questions? Visit unclemilton.com
Eruption Experiments
Experiments can be messy. Be sure to lay down some newspaper in case of excess “lava” flow. With each
experiment, note the reaction when the ingredients are mixed. Which combination of ingredients works the
best? Experiment with additional eruption formulas by adding more drops of dish soap to see how the
“lava” erupts and flows differently.
Experimen
t 1
1. Measure 1 teaspoon of baking soda into the central vent.
2. Measure 1 1/2 tablespoons of vinegar into a small cup.
3. Add 4 drops of dish soap into the vinegar.
4. Add 20 drops of red food coloring and 5 drops of yellow food
coloring into the vinegar mixture.
5. Pour the vinegar mixture into the central vent and enjoy the eruption.
6. Pour about half the vinegar mixture into the central vent to begin the eruption.
7. After the initial eruption, pour the remaining vinegar mixture into the central
vent to finish the eruption.
Experimen
t 2
ADULT SUPERVISION!
(use liquid dish soap, club soda, food coloring and antacid tablet)
1. Crush 1 antacid tablet into small pieces on a creased piece of paper.
2. Pour the crushed antacid down the crease into the central vent.
3. Measure 2 1/2 tablespoons of club soda into a small cup.
4. Add 6 drops of dish soap into the club soda.
5. Add 20 drops of red food coloring and 5 drops of yellow food coloring into the club soda mixture.
6. Pour about half of the club soda mixture into the central vent to begin the eruption.
7. After the initial eruption, pour the remaining club soda mixture into the central vent
to finish the eruption.