Uncle Milton Mars In My Room Light Up Planet - Manual

6+
2176
Battery Installation
Tool required - Small Phillips head screwdriver
Requires 4 “AA” alkaline batteries (not included).
Requires 2 “AAA” alkaline batteries (not included).
Wall Mount
1. Using a Phillips head screwdriver, remove the battery cover as shown.
2. Insert 4 "AA" batteries as indicated in the battery compartment and
replace cover.
3. IMPORTANT! Switch Mars in My Room to the ON position before
handing on the wall.
PLEASE NOTE: The unit will not activate without the remote control.
Wall Installation
Note: Product is only intended to mount on a vertical wall.
MARS
IN MY ROOM
MARS
IN MY ROOM
Light Up Planet
TM
On/Off
switch
Battery
cover
Hang
hole
Lander/Rover Name: Viking 2
Landing Date: September 3, 1976
Purpose of Mission: Mapping
the planet’s surface.
Lander/Rover Name: Curiosity
Landing Date: August 5, 2012
Purpose of Mission: To discover
if Mars could ever support life
forms like microbes.
Lander/Rover Name: Spirit
Landing Date: January 3, 2004
Purpose of Mission: Geological
research to characterize rocks
and soils that may hold clues
to past water activity.
Lander/Rover Name: Mars 3
Landing Date: December 2, 1971
Purpose of Mission: To study the
atmospheric composition and
measure mechanical and chemical
properties of the surface.
Mars 3
Spirit
Viking 2
Curiosity
Planet Set-up
Remove each of the Rover name stickers and apply below
the pinpoint of light that shows that Rover’s landing spot.
Batteries not included
Requires 4 x 1.5V AA/LR6 batteries
AA/LR6
x4
Batteries not included
Requires 2 x 1.5V AAA/LR03 batteries
x2
AAA/LR03