Uncle Milton Thor Lightning Energy Hammer - Manual

ACTIVATING THOR’S HAMMER
Now you can harness the power and energy of Thor’s Lightning Hammer! Use it to
find and detect metal. Then, watch as it flashes and sizzles with lightning energy.
First, test the energy charge of your hammer. Touch the Energy Plate on the top of
Thor’s Hammer to the Energy Charge Coin. Watch as this activates the light and
sound of Thor’s hammer.
Then, go on your own mission to detect other metals that will activate
Thor’s Hammer.
For each metal object you find, touch the Energy Plate on the top of the hammer
against it to see if it will activate with a charge of energy. If it does, you have
successfully found iron-containing metal, also known as ferrous metal, which is the
key ingredient needed to charge Thor’s Hammer.
PARTS INCLUDED
- 1 Thor Hammer
- 1 Display Base
- 1 Energy Charge Coin
BATTERY INSTALLATION
Tool required - Small Phillips head screwdriver
1. Using a Phillips head screwdriver, remove
the battery cover as shown.
2. Insert 3 "AAA" batteries as indicated in the
battery compartment and replace cover.
“WHOSEVER HOLDS THIS HAMMER, IF HE BE
WORTHY, SHALL POSSESS THE POWER OF....THOR”
“WHOSEVER HOLDS THIS HAMMER, IF HE BE
WORTHY, SHALL POSSESS THE POWER OF....THOR”
Energy Charge
Coin
Energy
Plate
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
Caution: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
BATTERY SAFETY INFORMATION
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the toy before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Different types of batteries or new and used batteries are not to be mixed.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the toy.
• The supply terminals are not to be short-circuited.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
• Do not dispose of batteries in fire. Battery may explode or leak.