Altitude pre-‐select mode – TruTrak Vizion 380-385 Operation Manual User Manual
Page 31
Vizion 380/385
31
Rev -‐ Initial
6.4.4. Altitude Pre-‐Select Mode
Sync the altimeter before performing
altitude pre-‐select (see section 6.1)
The
altitude
pre-‐select
mode
allows
the
user
to
pre-‐select
a
target
altitude
before
takeoff.
Once
engaged,
the
autopilot
will
proceed
in
a
climb
to
the
selected
target
altitude
and
synchronize
to
the
current
vertical
speed.
This
mode
is
accessed
by
pressing
the
ALT
button
once
while
the
autopilot
is
disengaged.
From autopilot disengaged, press ALT button, rotate the KNOB
to
select
target
altitude,
press
the
KNOB.
The
sequence
for
entering
an
altitude
pre-‐select
is
shown
in
figure
6.4.4a.
1)
500
foot
increments
when
turning
the
KNOB.
2)
100
foot
increments
when
pressing
and
holding
the
KNOB
in
while turning it.
Press ALT
Rotate KNOB
Press KNOB
Engage AP (Press KNOB)
Figure 6.4.4a