Top Flite Nobler - Manual (Page 6)

WING
19. Cut L. E. Sheet doublers from 1/16"x3" sheet and glue in place on wing
from center to W-5. Glue 1/16" x 3" L. E. sheeting to L. E. first, using spring
clips or pins to hold L.E. joint while it dries. See Fig. 12. Then glue and pin
other side to spars and ribs.
20. Glue upper T.E. sheet in place. Glue in W-15 and W-17, followed by all
l/16"x 1/4" rib capping strips.
MARK AND CUT LEVEL WITH TOP OF SIDES
FUSELAGE
FIG. 13
21. At this time the rear turtledeck sheeting is attached. Follow the instructions
closely and you will have no trouble:
a) Dampen top of sheeting with water and let soak for a minute or two.
b) Bend sheeting down against formers.. Mark the sheet where it overlaps
the sides and trim for exact fit.
c) Run white glue into formers and sides. Pull sheet down each side and
hold with pins and tape while it dries.
d) Trim front and rear flush with F-12 and F-16. See Fig. 13.
5