Top Flite Nobler - Manual (Page 3)

SUB-ASSEMBLIES
To speed building, by cutting down "waiting time," it is recommended that
certain components be sub-assembled f i r s t .
1. Glue F-2 (ply) doublers to F-l sides — make a left and a right side. See
Fig.1.
2. Make sawcut in one nylon nosewheel bearing as shown and snap bearing
over the formed noseleg between the tiller-arm and the coil. Slip the collar over
the leg from the top, followed by the other nylon bearing. Screw the bearings
to 1/4" ply F-3 using the 6-32 screws provided. Fig 2 shows assembled unit
3. Glue F-3 and F-4 (ply) to the shaped motor mounts. See Fig. 3.
4. Glue two F-20 pieces together as in Fig. 4. Use balsa cement for this joint,
Not white glue.
5. Join elevators with l/4"xl/2"x4" hardwood strip.
6. Glue F-17 to one end of shaped hatch block. See Fig. 5.
7. Join parts of wing plan to make one-piece plan. Use scotch tape and lots
of care.
2