Toa C-VD6 HH - Manual (Page 3)

4. NOMENCLATURE AND FUNCTION
Front-mounted facilities
VIDEO DISTRIBUTOR C–VD6
1 2
1
Rear-mounted facilities
3
4 5 6 7 8
Power switch (POWER ON / OFF )
To turn power on, press the switch.
Press it again to turn power off.
Power indicator lamp
AC cable
Input connector (A) (VIDEO IN A)
Input connector (B) (VIDEO IN B)
Input selector switch (2 IN 3 OUT/ 1 IN 6 OUT)
Set to the 1 IN 6 OUT position if 6 outputs are
needed. Shift the switch back to 2 IN 3 OUT if 2
different camera inputs are used.
Output connector (A) (VIDEO IN A)
Output connector (B) (VIDEO IN B)
In the event of 1 input and 6 outputs, the input A
signal is distributed to both outputs A and B.
When 2 input signals are distributed to each of 3
outputs, the input A signal appears at output A,
with the input B signal distributed to output B.
5. CONNECTION
• For 1 input/ 6 outputs
Set to the "1 IN 6 OUT" position.
• For 2 pairs of input/ 3 outputs
Set to the "2 IN 3 OUT" position.
Input signal
Connect to the input
connector (A).
6 outputs
An incoming signal to the
input conector (A) goes to
6 outputs. Input signal A
(input connector A)
Input signal B
(input connector B)
3 outputs (A)
An incoming signal to
the input conector (A)
goes to 3 outputs.
3 outputs (B)
An incoming signal to
the input conector (B)
goes to 3 outputs.
Note: Name plate is affixed to the unit's base.
3. HANDLING PRECAUTIONS
• Avoid locations where the unit is exposed to sunlight or heating device because this may badly influence the unit's case
or components.
• Do not place the unit in humid or dusty locations. If water gets into the units, electrical shocks or damage to the unit may
result.
• Never disassemble nor insert any metal objects into the units, nor touch any of its internal components because this may
result in electrical shocks or damage to the unit.
• Wipe down with a soft cloth when cleaning. Never use such volatile liquids as thinner and benzine because the unit's
finish or surface may be discolored or deformed.
• Always take hold of the plug when removing the power cable from the AC outlet. To avoid electrical shocks and fire,
never use a damaged power cable.
• To prevent an accident, leave the unit unplugged when it is not used for over two weeks.