Toa C-BC511A - Manual (Page 3)

2. GENERAL DESCRIPTION
The C-BC511A Ceiling Mounting Bracket is designed to be used for mounting the Combination Camera (C-
CC514, C-CC564 and C-CC574) and/or Network Combination Dome Camera (N-CC2564) to a ceiling directly.
By using this mounting bracket in conjunction with the C-BC511C or C-BC511C-S Ceiling Mounting Cover,
cameras can be mounted to gypsum board ceilings or other weak ceiling panel materials in which mounting
screws cannot be securely inserted.
3. HANDLING PRECAUTIONS
• Use the unit whenever the space between suspended ceiling panel and upper ceiling exceeds a height of
100 mm (3.9 inch).
• The ceiling panel to which the unit will be mounted must be no more than 40 mm (1.6 inch) in thickness.
When routing the cables from the ceiling if the unit is used in conjunction with the N-CC2564, the ceiling
panel must be 9 – 40 mm (0.4 – 1.6 inch) in thickness.
• To prevent the unit falls off, be sure to hang the safety wire first when installing the unit.
• Fix the camera to the bracket using the designated mounting screws, and ensure that they are securely
mounted without any play.
• Do not install the unit in locations exposed to constant vibration. Since the unit is not designed for vehicle or
ship use, do not install it in a vehicle or ship.
• The Combination Camera is solely designed for suspended installation. The dome of the mounting bracket
must be mounted facing down and perpendicular to a horizontal ceiling surface. Take special care not to
install the dome at a tilted angle.
• Do not give the unit a great shocks or vibration, as the unit may fall off and cause damage.