Toa C-BC450PM - Manual (Page 3)

YS-60B
(option)
* 1
C-BC450PM
Plain washer
Spring washer
Hexagon nut
Mounting bracket
(supplied with the camera)
Hexagon bolt M8 or W3/8
(screw length: 20 - 30 mm)
2. GENERAL DESCRIPTION
The C-BC450PM Pole Mounting Bracket is designed to mount the C-CV44-3 Outdoor-Use Color Camera
(option) on a pole in conjunction with the optional YS-60B Mounting Band.
It also permits the C-CV854D-3 Vandal Resistant Day/Night Camera (option) to be mounted on a pole in
conjunction with the optional YS-60B Mounting Band and C-BC850W Wall Mounting Bracket.
3. HANDLING PRECAUTIONS
• When mounting the units to a pole, pay special attention to the sway and strength of the pole, and mount it
securely at an appropriate height that will not cause the pole to sway and possibly weaken it. Moreover,
avoid mounting the units to a pole on which other objects susceptible to wind are also mounted.
• Do not install the unit in locations exposed to constant vibration. Do not install the unit in a vehicle nor ship.
• Avoid installing the units on sea or shore, or in locations exposed to corrosive gas, herbicides or other
sprayed liquid chemicals, or extraordinary combustible conditions.
• Do not give vibration or shock to the unit. The mounting bracket can be damaged or fallen down.
4. INSTALLATION
Install the camera to the mounting bracket using the mounting holes and screws shown in the figures below.
The YS-60B Mounting Band and screws are not included as standard accessories and should be obtained
separately.
4.1. Installing the C-CV44-3
• Attach the mounting bracket supplied with the camera using 2 sets of hexagon bolts, plain washers, spring
washers, and hexagon nuts.
• For the camera installation, refer to the instruction manual attached to the camera.
* 1 Use these holes to direct the camera in
the panning direction.