How to use the volume controls, Name label replacement, Connections – Toa RM-1100 User Manual
Page 6
6
7. HOW TO USE THE VOLUME CONTROLS
1. Using the Phillips screwdriver, rotate the microphone volume control (
) and AUX input volume control (
)
on the bottom surface fully counter-clockwise.
2. Making an announcement from the microphone, rotate the microphone volume control clockwise to adjust
the volume to an appropriate level.
3. Making broadcast from equipment connected to the AUX input, rotate the AUX input volume control
clockwise to adjust the volume to an appropriate level.
8. NAME LABEL REPLACEMENT
1. Raise the center of the label cover panel to remove it. (Figure 1)
2. Replace the name label.
3. Fit the cover panel in place lightly squeezing both ends of the cover panel. (Figure 2)
9. CONNECTIONS
Connect the RM-1100 unit to the main rack as follows.
14
13
Figure 1
Figure 2
To pre-amplifier
PP-025B line input
RM-1100
bottom-mounted terminal block
JP-0410 front panel middle row terminal block
C
E
H
Twin
shielded
cable
GND
GND
GND
GND
GND
GND
24 V CHIME
ACTI
GEM RM PWR
1
1
2
2
3
4
5
6
7
8
1
9
10
11
12
13
14
IN USE
REMOTE REMOTE
TIMER
GEN RM BUS
PWR FAIL
CTRL
AUX CONTROL