Toa ST-16A - Manual (Page 2)

Step 2. Loosen the leg locking knob to fully expand the legs. Lowering the slide leg adjustment till it hits the
stopper in the center of the external pipe permits maximum leg expansion.
Step 3. Tighten the leg locking knob to secure the legs.
Step 4. Loosen the internal pipe locking knob to raise the internal pipe to the desired height.
Step 5. Tighten the internal pipe locking knob to secure the pipe.
Step 6. Insert the bracket onto the top of the internal pipe, and mount the speaker on the stand.
Step 7. After determining the orientation of the speaker, secure the speaker by tightening the bracket fixing
knob.
Note: After installation completion, ensure again that every knob is tightened.
Step 8. After use, reverse the procedures 1 – 7 above to detach the speaker and fold the stand.
Note: Be sure to fold the stand after detaching the speaker from the stand.
[Storing mounting screws]
Speaker mounting screws for installing the FGM speakers can be stored
by mounting them into the storage holes provided in the bracket.
Use these holes to prevent the loss of screws while putting away the
equipment.
Put away the stand after use
Mount the speaker on the stand
Put up the stand
1130 – 1660 mm
1050 mm
Speaker mounting screw
(M5 x 20) x 2
Hexagon bolt
(M8 x 20) x 1
Washer x 1
Spacer x 1
Butterfly nut x 1
Weight: 1.7 kg (bracket included)
Bracket
Slide leg
adjustment
External pipe
Stopper
Stay
Bracket fixing knob
Internal pipe
Internal pipe
locking knob
Leg locking knob
Bracket
Bracket fixing
knob
Internal pipe
Internal pipe
locking knob
External pipe
Leg locking
knob
Stopper
Slide leg adjustment
Leg
Stay
Speaker mounting
screw
Bracket
Screw storage hole
3. PART NAMES
Stand (when in use) Stand (when folded) Accessory