Toa PJ-304 - Manual (Page 3)

6. INSTALLATION
Step 1. Secure the swivel bracket to the ceiling or wall with 3 screws.
Loosen the safety screw (for fall prevention) as shown below.
Before installation
Step 2. Mount the speaker to the swivel bracket.
Loosen the speaker fixing screws as shown below.
2-1. Pass the speaker cord through the cord entry hole in the swivel bracket.
2-2. Slip 2 speaker fixing screws into the swivel bracket's screw slots.
2-3. Tighten the speaker fixing screws and safety screw.
Before installation
Step 3. Connect the 60 cm (1.97 ft) speaker cord
to the routed speaker cable.
Step 4. Loosen the swivel bracket's butterfly nut,
adjust the speaker angle, and then
retighten the butterfly nut.
Ceiling
Swivel bracket
(accessory)
Safety screw
Tapping screw 4 x 16 (accessory)
Note
If these screws are not appropriate for the ceiling material,
separately prepare the proper screws.
Note
Loosen the safety screw until it's tip does not stick out from the bracket surface.
If the screw tip sticks out, this obstructs the insertion of the speaker bracket in Step 2.
Ceiling
Cord entry hole
Swivel bracket
Speaker
Safety screw
Safety screw hole
Speaker bracket
Speaker fixing screw
Note
Ensure that the safety screw is fit into the
given hole in the speaker bracket.
Speaker cord 60 cm (1.97 ft)
2
-3
2
-3
2
-1
2
-2
Note
These screws are pre-screwed into
the bracket at the factory.
Loosen them so that they can slip into
the swivel bracket's screw slots.
Speaker
Speaker cord 60 cm (1.97 ft)
butterfly nut
HOT (black)
COM (white)
Lead-in cable
4
3