beautypg.com

Installation – Toa BS-680FC User Manual

Page 2

background image

3. INSTALLATION

Step 1. Loosen one each of the screws on both

sides of the speaker, then remove the
baffle.
You can remove the baffle by loosening
the screw without taking it out.

Step 2. Install the cabinet on the wall.

The cabinet has knockout holes (ø20.5 mm or ø0.81") for cable routing.
Remove the desired knockout hole depending on the wiring method, and route cables.

2-1. When installing the cabinet on the wall using the hanging holes:

(1) Fix 2 supplied screws (tapping screws 4 x 16)

to the wall leaving about 5 mm (0.2") space
from the wall surface.

(2) Remove the cabinet's knockout, then run the

cables routed from the wall through this hole.
In the case of exposed wiring, fit the supplied
rubber grommet into the knockout hole.
Note: Cut a hole in the grommet's thin

membrane to match the cable size.

(3) Hook the cabinet onto the stick-out screws,

then tighten the screws.
Tip: The shape of cabinet's hanging hole is

so designed to prevent the cabinet from
falling easily even if an outward force is
applied to.

2-2. When installing the cabinet on the wall using other holes:

(1) Remove the cabinet's knockout, then run

the cables routed from the wall through this
hole.
In the case of exposed wiring, fit the supplied
rubber grommet into the knockout hole.
Note: Cut a hole in the grommet's thin

membrane to match the cable size.

(2) Install the cabinet on the wall using the

mounting holes [a], [b] or [c] shown at right.
Note: Since no mounting screws are

supplied with the speaker, separately
prepare them appropriate for the
construction of wall and its thickness.

2-3. When mounting the cabinet into the wall:

(1) Make a mounting hole of 260 x 175 mm

(10.24" x 6.89") in the wall.

(2) Remove the cabinet's knockout hole, run

the cables through this hole, then install
the cabinet using 4 supplied screws
(tapping screw 4 x 16).
Fit the supplied rubber grommet into the
knockout hole.
Note: Cut a hole in the grommet's thin

membrane to match the cable size.

Loosen

Tighten

Baffle

Cabinet

Note: To remove, pull in the arrow

direction after loosening screws.

Cabinet

83.5 mm (3.29")

About 5 mm (0.2")

Hanging hole

Wall

Tapping screw 4 x 16

(accessory)

Knockout hole (ø20.5mm or ø0.81")

Cabinet

Knockout hole: ø20.5 (0.81)

36 (1.42)

36

(1.42)

60 (2.36)

60 (2.36)

115 (4.53)

4-3.5 x 6.5 (0.14 x 0.26) [a]

2-5.5 x 10
(0.22 x 0.39) [c]

4-ø4.5 (0.18) [b]

Unit: mm (in)

The figure shows BS-680F.

Cabinet

Knockout hole: ø20.5 (0.81)
Sides: 4 holes
Bottom: 2 holes

wall

286 (11.26)

260±3

(10.24±0.12)

175±3

(6.89±0.12)

150

(5.91)

Speaker
cable

Tapping screw 4 x 16 (accessory)

Unit: mm (in)

This manual is related to the following products: