beautypg.com

Installation – Toa BS-678BT User Manual

Page 2

background image

Step 3. Make wiring.

3-1. Insert the lead-in cables (cables from the amplifier) and

lead-out cables (cables to other speakers) into the
push-in connector attached to the cabinet.

[Applicable cable]

Solid wire:

ø0.8 to ø1.6 mm
(AWG 20 – 14)

Stranded wire (7-core): 0.75 to 1.25 mm

2

(AWG 18 – 16)

Step 4. Hook 2 V-shaped springs attached to the baffle into the

slotted holes of the cabinet, then push the baffle onto
the cabinet.

Note
When the speaker mounting
orientation is vertical, pinch and
rotate the logo mark on the baffle
into the right position.

3-2. Insert the fasten terminals fitted at the ends of both the

HOT (black) and COM (white) cables from the input
connector on the cabinet into the taps of the matching
transformer on the speaker unit.

Connect the COM (white) cable to the transformer's
COM tap, and the HOT (black) cable to the desired
transformer's input tap. (Refer to the figure below.)

Step 2. Install the cabinet to the wall using the supplied tapping

screws 4 x 35. In this case, route the cables from a
cable entry hole.

Note
The speaker can be installed in a vertical or horizontal
orientation. Either concealed in-wall wiring or open
wiring are available for speaker cable connection.

3. INSTALLATION

Step 1. Pull out the baffle, unlatch 2 V-shaped springs, then

remove the baffle from the cabinet.

9 mm

(0.35”)

COM (white)

Note:

The figure shows wiring for the BS-678/ 678B.

HOT (black)

Input connector

To the next
speaker

From
the amplifier

3.3kΩ

1.7kΩ

COM

6.7kΩ

13kΩ

HOT (black)

COM (white)

Matching transformer

[Cabinet mounting dimensions]

3-ø5 (0.2)

Unit: mm (in)

Cabinet outside
dimensions

83.5

(3.29)

250 (9.84)

83.5

(3.29)

190

(7.48)

Cable entry hole
(for open wiring at horizontal mounting)

Cable entry hole
(for concealed wiring at horizontal mounting)

Cable entry hole
(for concealed and open wirings at vertical mounting)

Impedance

1.7 kΩ

3.3 kΩ

6.7 kΩ

13 kΩ

100 V line

6 W

3 W

1.5 W

0.8 W

70 V line

3 W

1.5 W

0.8 W

0.4 W

Cabinet

Matching transformer

HOT (black)

COM (white)

Baffle

Notches for open wiring

Screws for
horizontal mounting

Screws for
vertical mounting

Tapping screws 4 x 35 (accessory)

Cabinet

Input connector

Baffle

Cabinet

Baffle

V-shaped spring
Squeeze the spring to detach
from the cabinet.

Cabinet

This manual is related to the following products: