beautypg.com

Warning – Toa HY-TM7W-WP User Manual

Page 3

background image

Step 2. Mount the speaker system to this bracket.

Mount the speaker system vertically, as shown in the figure.

Fix the speaker to the mounting bracket at all 3 indicated places.

2-1. Fix this bracket to both ends of the side angle plate of the speaker front.

Use the supplied bolts (with spring and plain washers) and spacers.

2-2. Fix this bracket to the speaker’s rear bracket.

Fix to the rear bracket’s endmost hole.

Use the supplied bolt (with spring and plain washers), J-spacer, and flange nut.

For details, refer to the procedures (1) to (3) as shown below.

• Use safety wires when installing speakers. If not used, personal

injury could result if a speaker should accidentally fall.

• Owing to the speaker's size and weight, be sure that at least two

persons are available to install the unit.

Failure to do so could result in personal injury.

• Tighten the bolts securely, as instructed below. Failure to follow

instructions precisely could result in a falling speaker and potential

personal injury.

· Ensure that all bolts are securely inserted as far as their threads go,

then securely fasten each bolt with a nut.

· Tighten all the bolts with the designated tightening torque. For

tightening, use a Phillips screwdriver, or open- or box-end wrench.

WARNING

This bracket

HX-7B-WP or HX-7W-WP

J-spacer

(accessory)

Rear bracket

(1) Lightly secure.

(3) Tighten firmly.

(2) Insert.

Flange nut

for M6 (accessory)

Hex head

bolt M6x30

(accessory)

Tightening

torque: 5 N·m

Spacer ø9.2 (0.36")

(accessory)

Hex head bolt

M6x12(accessory)

Side angle plate

Protection cover

Note

Remove the

protection covers

from the side

angle plates

before joining.

Tightening torque:

5 N·m

2

-1

Note

Similarly, fix this bracket to the end of the

side angle plate on the opposite side.

2

-2

This bracket

HX-7B-WP or HX-7W-WP

[Completed installation]

Step 3. Attach safety wires for protection against falls.

Regarding the attaching method of safety wires,

refer to the operating instructions supplied with

HX-7 Series speaker system.

Note

After tightening the bolt, ensure that

the J-spacer is firmly fixed.

This manual is related to the following products: