Installation – Toa HY-RR2 User Manual
Page 2

Printed in Indonesia
533-06-106-80
4. INSTALLATION
Refer to the F-2352SC speaker's instruction manual for information.
4-1. Direct mounting to a weak ceiling panel
Use the HY-RR2.
Fold the HY-RR2 Reinforcement Ring in half* and insert it
through the mounting hole in the ceiling panel, then open it
with its tabs facing up.
Place the ring on the ceiling panel aligning it with the
mounting hole.
* The HY-RR2 is too large to be inserted into the mounting
hole unless folded.
4-2. Mounting to a ceiling frame
4-3. Ceiling mounting to a larger than specified hole
Use the HY-RR2 in conjunction with the optional
HY-TR1 Trim Ring.
Note
Refer to the instruction manual included with the
HY-TR1 for the correct ceiling mounting procedure.
4-4. Mounting to an anchor bolt
Use the HY-RR2 in conjunction with the optional HY-AH1
Anchor Hanging Bracket.
Note
Refer to the instruction manual included with the HY-AH1
for the correct mounting procedure.
Mounting hole
ø200 mm (7
7
/
8
")
HY-RR2
HY-RR2 placed on ceiling panel
These tabs must
face upward,
away from the hole.
HY-TB1 (optional)
Ceiling panel
HY-RR2
Ceiling frame
Use the HY-RR2 in conjunction with the
optional HY-TB1 Tile Bar Bridge.
Note
Refer to the instruction manual included
with the HY-TB1 for the correct ceiling
mounting procedure.
HY-TR1
ш200 – ш300 mm
(7
7
/
8
" – 11
13
/
16
")
Ceiling
panel
HY-RR2
Speaker unit
Anchor bolt
Ceiling panel
HY-AH1
(optional)
HY-RR2