Cabletron Systems CSX200 - Manual (Page 40)

Chapter 4: Installation
4-6 CSX200 Installation Guide
Figure 4-3 CSX200-COMP/ENCR Module Installation
Installing the CSX200
The CSX200 may be installed on a tabletop, on a shelf, or in a 19-inch rack.
Tabletop and Shelf Installations
The following two subsections provide guidelines for installation on a tabletop or shelf.
To install the CSX200 on a tabletop or shelf, perform the following procedure:
• Locate the CSX200 within seven feet of its power source with an unrestricted free surface area
as shown in
Figure 4-4 , on the following page.
• Locate the six round rubber feet included with your CSX200, and peel the paper backing off
the round rubber feet. Place one rubber foot near each of the four corners of the CSX200, and
evenly space the remaining two near the center.
• Complete the installation by connecting power as described in Powering the CSX200 .
!
CAUTION
Before performing tabletop or shelf installation procedures, ensure that the requirements
outlined in the section,
Installation Guidelines on page 4-1, are met.
Standoff Screws
Standoff
D-Type
Connector
CSX-COMP/ENCR
D-Type
Connector Pins
Detail
2204N01