Cabletron Systems CSX200 - Manual (Page 36)

Chapter 4: Installation
4-2 CSX200 Installation Guide
Removing the CSX200 Cover
The cover must be removed to install a WAN Port Interface Module.
To remove the chassis cover, proceed as follows:
• If the CSX200 is installed, unplug the power cord from the rear of the CSX200 chassis.
• Disconnect all network cables attached to the CSX200.
• Use a flat-blade screwdriver to remove the cover screw attaching the cover to the CSX200
chassis (refer to
Figure 4-1 ) and save the screw.
• Remove the cover by sliding it back until it clears the front of the chassis and then lifting it
straight up and off the chassis.
NOTE
The CSX200 must have a WPIM installed before you can begin configuring the device.
!
CAUTION
DO NOT REMOVE THE COVER FROM THE CSX200 WHILE POWER IS APPLIED
TO THE UNIT.
DO NOT POWER UP THE DEVICE AGAIN UNTIL THE COVER AND SCREWS ARE
IN PLACE.
DECKEL VON DAS CSX200 NICHT ABZIEHEN UNTER SPANNUNG.
CSX200 NICHEINSCHALTEN SO LANG DER DECKEL UND SCHRAUBEN NICHT
EINGEBAUT SIND.
NO DEBE DE REMOVER LA TAPA DURENTE QUE ESTE CONELTADO A LA
CORRIENTE.
NO ENCHUFE A LA CORRIENTE HASTA QUE LA TAPA Y LOS TORNILLOS ESTEN
EN SU LUGAR.
TIP
Before disconnecting any network cables, mark them according to their associated port
numbers. This will make reinstallation easier.