Toa DP-SP3 - Manual (Page 5)

5
• When moving the unit, be sure to remove its power
supply cord from the wall outlet. Moving the unit
with the power cord connected to the outlet may
cause damage to the power cord, resulting in fire or
electric shock. When removing the power cord, be
sure to hold its plug to pull.
• Do not block the vents on the unit’s front and rear
panels. Doing so may cause heat to build up inside
the unit and result in fire. Also, periodically clean
the ventilation slots of dust.
• Avoid installing the unit in humid or dusty locations,
in locations exposed to the direct sunlight, near the
heaters, or in locations generating sooty smoke
or steam as doing otherwise may result in fire or
electric shock.
• Be sure to follow the instructions below when rack-
mounting the unit. Failure to do so may cause a fire
or personal injury.
· Install the equipment rack on a stable, hard floor.
Fix it with anchor bolts or take other arrangements
to prevent it from falling down.
· When connecting the unit's power cord to an AC
outlet, use the AC outlet with current capacity
allowable to the unit.
(Every version except the DP-SP3 CU for US)
· The supplied rack-mounting screws can be used
for the TOA equipment rack only. Do not use them
for other racks.
(DP-SP3 CU for US)
· Rack-mounting screws are not supplied with the
unit. Prepare them that are appropriate for the
equipment rack.
· Be sure to complete installation and cable
connections before connecting the unit’s power
plug to the power source. When uninstalling the
unit or disconnecting the unit’s cables, be sure to
disconnect the power plug from the power source
first. Doing otherwise may result in electric shock.
• LAN Connector cannot connect to Connector which
might catch overvoltage.
When the Unit is in Use
• If dust accumulates on the power supply plug or
in the wall AC outlet, a fire may result. Clean it
periodically. In addition, insert the plug in the wall
outlet securely.
• Switch off the power, and unplug the power supply
plug from the AC outlet for safety purposes when
cleaning or leaving the unit unused for 10 days or
more. Doing otherwise may cause a fire or electric
shock.
The lighting flash with arrowhead symbol, within an equilateral triangle, is intended to alert the
user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may
be of sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence
of important operation and maintenance (servicing) instruction in the literature accompanying the
appliance.