Toa WA-1822C - Manual (Page 9)

9
7. USING A WIRED MICROPHONE
0 10
Power switch
Wired microphone
terminal
Figure shows
the WA-1822C.
Tone control
Wired microphone volume control
LINE OUT AUX IN
LOW
AUX IN (MONO)
HIGH
WIRED MIC TONE
Step 1. Connect the wired microphone to the
Wired Microphone terminal.
Step 2. Set the power switch to the ON
position.
Step 3. Set the Wired Microphone volume
control to Position 5.
Step 4. Adjust the sound quality using the
tone control.
8. USING A WIRELESS MICROPHONE
0 10
Power switch
Tone control
Figure shows
the WA-1822C.
Wireless microphone
volume control
LINE OUT AUX IN
LOW
AUX IN (MONO)
HIGH
WIRED MIC TONE
Step 1. Set the power switch to the ON
position.
Step 2. Set the wireless microphone's power
switch to the ON position. (The Radio
Signal Reception indicator lamp will
light.)
Step 3. Adjust the volume by setting the
corresponding Wireless Microphone
Volume control (either WIRELESS
MIC1 or WIRELESS MIC2) to Position
3 if a clip-on wireless microphone is
used, or "7" if a hand-held wireless
microphone is used.
Step 4. Adjust the sound quality using the
tone control.
Notes
• Use only TOA wireless microphones.
• Set the wireless microphones 1 and 2 to different channels from each other. Otherwise, radio interference or
noise may occur.
• Keep the wireless microphone 3 – 20 m away from the Meeting Amplifier.
• If the wireless microphone is positioned less than 3 m from the Meeting Amplifier, feedback noise or radio
interference could result.
• When simultaneously using 2 different channels, keep the 2 wireless microphones at least 50 cm away from
each other.
• When the Meeting Amplifier's power switch is set to the ON position, if the amplifier's Radio Signal
Reception indicator lamp lights before the wireless microphone's power switch is turned ON, this indicates
that the currently set channel is in use. In such cases, change the channel.