Toa WA-1822C - Manual (Page 14)

Step 1. Set the power switch to the ON position.
Step 2. Press the EJECT [ ] to open cassette door, and insert the cassette with its exposed tape surface
facing down.
Step 3. Select the tape operating mode using the Operating Mode selector switch. Details concerning the
operating mode are explained on p. 16.
Step 4. Press the Recording button [ ], and the deck will be put in recording standby mode. Both the
Recording indicator lamp and the Pause indicator lamp will light, and the Direction indicator lamp will
flash.
Step 5. Press the Pause button [ ] or the flashing Play button [ ] or [ ]. The tape will begin to record,
and the Direction indicator lamp will light to indicate the current tape direction.
Step 6. To temporarily stop the tape during recording, press the Pause button [ ]. The deck will be put in the
same standby mode as is described in Step 4.
Step 7. To completely stop the tape during recording, press the Stop button [ ].
Notes
• All input sounds are mixed and recorded.
• Recording cannot be made when the cassette tape's erasure prevention tab is removed.
• By pressing the Reset button to reset the Tape Counter to [0000] or by recording the tape counter reading
before recording, the point at which the recording was started can be made clear.
14
Lights Lights Either lamp flashes.
9.4. Recording
Because the WA-1822C's cassette deck features automatic recording level adjustment, no manual recording
level settings are necessary.
Eject
Reset button
Tape counter
Cassette door
Stop button
Play button
(Direction indicator lamp)
Pause button
(Pause indicator lamp) Recording button
(Recording indicator lamp)
Operating mode selector switch