Toa WA-1822C - Manual (Page 7)

7
1. Power switch
Turns the power ON and OFF when pressed.
2. Power/Battery indicator
Lights green when the power switch is set to the
ON position, and gets dark when the batteries
begin to lose their charge during battery-powered
operation.
3. Handle
Raise and use this handle to carry the unit.
Note: Use this handle only to transport the unit.
Never suspend the unit from this handle.
4. Radio signal reception indicator lamps
Each lamp lights orange when the unit receives a
radio signal from the wireless microphone.
5. Wireless microphone volume controls
As a general guideline, set these controls to
Position 3 for clip-on microphones, and to
Position 7 for hand-held microphones.
These positions are marked with larger dots.
6. Wired microphone volume control
Adjusts the volume of the microphone connected
to the Microphone Input terminal. As a general
guideline, set this control to Position 5 (larger dot
marking).
7. Cassette deck (WA-1822C only)
Details of operation are described on p. 11 of this
manual.
8. Battery compartment
Holds the unit's cartridge-type battery case.
9. Internal speaker ON/OFF switch
ON: Enables the internal speaker.
OFF: Disables the internal speaker.
10. External speaker terminal
Connect an 8 – 16 Ω speaker rated for at least
20 W to this terminal. Note the correct polarities
when connecting.
11. Wireless tuner receptacles
Accommodate optional wireless tuners.
12.AC inlet
Connect the supplied AC power cord to this inlet.
13. Tone control
Rotate clockwise to accentuate high-frequency
sounds, and counterclockwise to accentuate low-
frequency sounds.
14. Wired microphone terminal
Connect a wired microphone here.
(Applicable microphone: 600 Ω, –48 dB*,
unbalanced type)
15. External input volume control
Adjusts the sound volume of the connected
external equipment.
16. External output terminal
Connect an external cassette deck or amplifier to
this terminal.
(1 kΩ, –10 dB*)
17. External input terminal
Used to connect a portable CD player or other
sound source.
RCA jack x 2 (monaural)
(10 kΩ, –20 dB*, unbalanced type)
18. Compartment cover
19. Cord hanger
The lightly bundled power cord can be hooked
onto this hanger for storage.
20. Component compartment
Used to store such components as the power
cord, wired and wireless microphones, and dust
cover.
21. Battery case
Insert 8 R20P ("D" cell) batteries, noting the
correct polarities.
22. Tuner cover
This cover must be attached after installing the
tuner.
* 0 dB = 1 V