Tie Down Slotted Receiver - Manual

TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336
www.tiedown.com (404) 344-0000 Fax (404) 349-0401
011713,A1291
Slotted Receiver
with Flange
GalvX #86902 / Galvanized #86920
MAKE YOUR DOCK A DESTINATION
Instruction Sheet #08177
Warnings
Dock Sides Slotted Receivers with Flange are designed to
be used on wooden or solid steel side panel docks/decks
only. Please refer to dock/deck manufacturers product
specifications to determine if dock can accommodate
receiver installation plus the weight of accessories and
items/persons placed on them.
Dock Sides Slotted Receivers with Flange should only be
installed on wood docks/decks that are free of defects,
wood decay and/or rot. Periodic inspections of wood
supporting Dock Sides Receivers is required and wood must
be replaced if decay or defects are present.
Caution should be used when operating electrical tools near
water. Failure to use caution can result in injury or death.
Tools Required:
Pencil
Tape Measure
Cordless Drill
3/8" Drill Bit
1/4" Drill Bit
9/16” wrench or socket
1
5
6 7
2
8
6
2
4
3
5
4
Hot Dipped Galvanized Finish - #86920 Parts List
# Part # Qty Description
1 86920-1 1 Flanged Slotted Receiver
2 13211 4 5/16"-18 x 3" Eye Bolt, Zinc
3 10637 4 5/16"-18 Flange Nut
4 10598 2 6" Nylon Lanyard
5 10680 2 3/8" x 2-1/2" Galv Carriage Bolt
6 10017 3 3/8" Galv Flat Washer
7 10014 2 3/8" Galv Hex Nut
8 10678 1 3/8" x 3-1/2" Galv Lag Bolt
GalvX Dual Coat Finish - #86902 Parts List
# Part # Qty Description
1 86902-1 1 Flanged Slotted Receiver
2 13211 4 5/16”-18 x 3" Eye Bolt, Zinc
3 10637 4 5/16”-18 Flange Nut
4 10598 2 6" Nylon Lanyard
5 10680 2 3/8” x 2-1/2" Galv Carriage Bolt
6 10017 3 3/8" Galv Flat Washer
7 10014 2 3/8" Galv Hex Nut
8 10678 1 3/8” x 3-1/2” Galv Lag Bolt