ThermoWorks P795 PRINTING DATALOGGER THERMOMETER - Manual (Page 8)

E.g. of the instrument’s LCD by activated logging mode:
On the bottom you can see the percentage of the occupied
memory(0..99%). If a calibration option is activated the
display is alternating between displaying memory status and
calibration information.
1.5 Recalling the memory data (HOLD MAX MIN AVE)
After pushing first time the key [HOLD MAX MIN AVE] the actual values will be held
on the display. Pushing again the key [HOLD MAX MIN AVE], the saved maximum-,
minimum and average values will be displayed.
Note: During the recall of the memory data the extremes (MAX MIN) and the
average value (AVE) will not be calculated or carried on.
Clearing the memory (MAX MIN AVE)
Press [CLEAR] key once to erase the stored maximum, minimum and average from
memory. On the display appears Clr. – After erasing the memory the instrument
automatically reverts back to measuring mode indicating the actual measured value
again.
1.6 Measuring rate (Normal-Mode/FAST-mode/Filter-Mode)
The instrument has three different response times to select:
Normal-Mode:
high resolution (0,001 from -199,999 to +199,999)
Fast-Mode: reduced resolution (0,01 from -199,99 to +199,99)
Filter-Mode: high resolution (0,001 from -199,999 to +199,999)
Press [FAST/] key to change the measuring rate.
By using the Filter-Mode the instrument is performing a moving average to stabilize
the dispayed measurements.
After turning on the instrument it is in the Normal-Mode. After pressing once the
[FAST/] key the instrument switches to the Fast-Mode. Pressing the same key
once again the instrument switches to the Filter-Mode.
E.g. Display with activated Filter-Mode:
The arrow on the top indicates that the instrument is working
in the Filter-Mode.
Note: After switching off the instrument, this function is automatically deactivated.
1.7 AUTO-OFF-function
EAoF = Enable Auto-off
dAoF = Disable Auto-off
Press [ESC/AUTO-OFF] key once. On the display appears EAoF. Now the
instrument switches off automatically after app. 30 minutes. Press [ESC/AUTO-OFF]
key again. On the display appears dAoF. Now the Auto-Off-function is deactivated.
Note: After switching off the instrument, this function is automatically deactivated.
1.8 TARE-Function(ZERO-Mode F1)