ThermoWorks P795 PRINTING DATALOGGER THERMOMETER - Manual (Page 3)

1. Handling
1.1 General advice
- For cleaning the instrument please do not use abrasive cleaner but a dry or
wet piece of cloth.
- Please store the measuring instrument in a dry and clean place.
- Avoid any force like shocks or pressure to the instrument.
- Do not use force to connect the probe or interface plugs in. The interface
plug is different from the probe plug.
- If no sensor is connected to the instrument while switching on „open“ shows
on the display (Please refer to chapter error codes/troubleshooting).
- A retractable stand on the back of the instrument allows it to be used as a
bench top instrument.
1.2 Operation
Before switching on the instrument, connect the probe/s to the instrument and insert
the battery (Please refer to chapter 2. Power supply/changing the battery). A number
on the instrument’s housing marks each port.
1.3 Switching on and off
By operating the ON/OFF-key the instrument switched on or off. After switching on
the instrument indicates a full segment test for 15 seconds, then it starts to function
in measurement mode indicating the actual measurement value.
1.4 Menu
The adjustments of the instruments function: measurement value, calibration of
Probes, deactivation of channels, for example, are selected
from the menu structure. Enter into the main menu by
pushing [ENTER/MENUE]. Use the up and down keys []
to select the required menu. Push [ESC] to revert back to the
measuring mode.
Up and down keys
key [ESC]
key [ENTER/MENUE]
Menu structure
Unit Lin2 CAL Chnl Lo6
°C T1-T2 OFF OFF OFF
°F OP1 ON ON
Ohm OP2
OP3
OP4