TeeJet FieldPilot Install John Deere 9x00-9x20 - Manual (Page 28)

24
www.teejet.com
FieldPilot ®
13. install steering disengage sensOr
The steering disengage kit (GG) is used to automatically disengage FieldPilot when the steering wheel is turned.
The sensor must be mounted so that it has a 1/8” clearance from the magnets. There are two mounting options:
1. Using self tapping screws, mount the aluminum bracket from
(GG) . Bend it as shown and mount the magnets
to the spokes of the steering wheel. Install the sensor and ensure the sensing tip passes over the magnets with
a clearance of 1/8”.
2. Remove the shrouds around the steering base. Locate the steering shaft and attach 3 magnets to the shaft,
then install the bracket and sensor as shown so that there is a clearance of 1/8” between the magnets and
sensor.
Route the cable and ensure it will not get tangled in any moving components. Connect the sensor to the SCM
harness.
Figure 1-26: Installing the Steering Disengage Switch (Kit 91-07011)