Fieldpilot, Cable, Cable routing – TeeJet FieldPilot Install Case MX Magnum User Manual

Page 16

www.teejet.com

FieldPilot

9. install ValVe control caBle

Route the valve cable from the valve, underneath the cab, and into the cab through the cable grommet in the

back right of the cab.
Figure 1-12: Install the Valve Control Cable

10. install steering disengage switch (kit 91-07011)

The steering disengage kit

(S)

is used to automatically disengage FieldPilot when the steering wheel is

turned. The magnets mount on the steering shaft or other rotating part of the steering wheel and the sensor

mounts so that there is a 1/8” clearance between the sensor and magnet. One option is to remove the

cowling around the steering column. Drill a hole as indicated and mount the sensor inside the cowling.

Usually three or four magnets are adequate.
Pictures: 8143, 2915, 2916
Figure 1-13: Install Steering Disengage Switch (Kit 91-07011)

Cable

routing