TeeJet FieldPilot Install Case MX Magnum - Manual (Page 15)

www.teejet.com
13
FieldPilot ®
8. install PressUre, tank and load sense hoses
Install pressure and tank hoses (J) to the branches of the run-tees installed in Step 6. Route the hoses down
the FieldPilot valve as shown.
Figure 1-10: Install Pressure, Tank and Load Sense Hoses
Connect the hose from the P port on the orbital to the P port on the FieldPilot valve. Connect the hose from
the T port on the orbital to the T port on the FieldPilot valve.
Install the load sense hose
(K) to the JIC fitting (M) on the end of the load sense shuttle installed in Step 7.
Route the hose down to the hydraulic control block as shown and connect to the LS port on the block.
Make sure the hoses are secure and routed for problem free operation. Securely tighten all connections.
Figure 1-11: Install Pressure, Tank and Load Sense Hoses
J
J
K
K