Supply voltage mounting of wheel sensor, Supply voltage, Mounting of wheel sensor – TeeJet LH 865 User Manual

Page 11

LH 865 C

APACITY INDICATOR

– O

PERATORS MANUAL

& F

ITTING INSTRUCTION

LH A

GRO

SUPPLY VOLTAGE

The supply voltage is 12 Volt.
Connect the supply cable to 12 V in a way that the supply is switched off. When
the ignition is switched off.

OBS:

Blue cable to +

Brown cable to –

Lead the cable to the connection box and connect as shown on the circuit board.

MOUNTING OF WHEEL SENSOR

Mount the sensor on one of the steering wheels.
The magnet is to mount direct on hub or rim. The supplied 20 mm collar must be
used as support.
Mount as follows:

1. Mount the bracket for the censor. (Screw or weld).
2. Mount the sensor in the bracket.
3. Mount the sensor as illustrated below (cut 4 mm thread).

5-8 mm

Magnet can be painted

Washer

4. Turn the wheel and check the distance between sensor and magnet (5-8mm).
5. Lead the cable to connecting box 2 and connect it as described.
6. Fix the cable and control that it will not be squeezed or worn.