TeeJet LH 865 - Manual (Page 10)

LH 865 C APACITY INDICATOR – O PERATORS MANUAL & F ITTING INSTRUCTION
10 LH A GRO
FITTING INSTRUCTIONS FOR LH 865
NOTE! See description of the system page 4
FITTING AF MONITOR BOX
Normally the grain loss monitor (the instrument box) is to place on the ground in
the right corner of the driver's cab. This is the most practical place when the
operator is to read the display.
1.
When the mounting place is located this should be marked. The holes for
the fixing and for the cables are drilled using the supplied drill gauge.
2. Put the cable through the hole and fix the foot.
3. Adjust the tilt position of the monitor. Raise the sleeve and the screws for
the tilt adjustment to be tightened. Can the upper screws not be reached by
raising the sleeve this can carefully be pulled down.
FITTING OF CONNECTING BOX 1
Connection box 1 should be mounted under the floor of the driver's cab where it
will be well protected and where it at the same time is most suitable as regards
connecting of power and possible extra equipment.
The cable from the instrument box is lead through the cable lead in and connected
on the circuit board in accordance with the directions.
NB! When the cable leads in are adjusted it is most important that exact amount is
cut off so that the lead in is tight around the cable.
FITTING OF CONNECTING BOX 2
Connection box 2 is mounted at the rear end of the combine harvester, normally
on the right side. The box should be situated where it will be best possible
protected and most suitable as regards the later cabling on the combine.
The cable connecting the two connecting boxes is mounted as instructed.
Lead the cable along the existing supply mains, alongside hydraulic tubes etc. to
the connecting box 1. Attach it with the supplied cable clamps.
OBS: Beware of rotating parts, sharp edges and high temperatures (exhaust etc.).
FITTING OF SUN SENSOR
The sun sensor is mounted on the driver's cab or on the grain tank. It must be
situated so that shadows will never fall on it.
Lead the cable to connecting box 1 where it is connected as shown. Where
impossible to fasten the cable to wires, tubes, etc. the supplied cable brackets can
be used.