TeeJet LH 765 - Manual (Page 9)

LH 765 G RAIN LOSS MONITOR – O PERATORS MANUAL & F ITTING INSTRUCTION
LH A GRO 9
FITTING INSTRUCTIONS FOR LH 765
NOTE! See description of the system page 4
FITTING AF MONITOR BOX
Normally the grain loss monitor (the instrument box) is to place in the right corner
of the driver’s cab. This is the most practical place when the operator is to read the
display.
1.
When the mounting place is located this should be marked. The holes for
the fixing and for the cables are drilled.
2. Put the cable through the hole and fix the bracket.
3. Adjust the tilt position of the monitor and tighten the screws.
FITTING OF CONNECTING BOX
The connecting box is mounted at the rear end of the combine harvester, normally
on the right side. The box should be situated where it will be best possible
protected and most suitable as regards the later cabling on the combine.
Mount the cable from the grain loss monitor as instructed on the circuit board.
SUPPLY VOLTAGE
The supply voltage is 12 Volt.
Connect the supply cable to 12 V in a way that the supply is switched off. When
the ignition is switched off.
OBS:
Blue cable to +
Brown cable to –
Lead the cable to the connection box and connect as shown on the circuit board.
CABLES TO THE SENSORS
Lead the multi cable to the sensors along the existing cables, alongside hydraulic
tubes, etc. to the rear end of the combine harvester, (normally on the right side
where the connection box should be fitted). Attach it with the supplied cable
clamps.
OBS! Beware of rotating parts, sharp edges and high temperatures (exhaust
etc.).