TeeJet LH 765 - Manual (Page 12)

LH 765 G RAIN LOSS MONITOR – O PERATORS MANUAL & F ITTING INSTRUCTION
12 LH A GRO
2.
Turn the walker to the lowest position and make a mark (A) on the side of
the machine at a right angle to the fitted cable fastener.
Turn the walker to the highest position and make a mark (B) on the side of the
machine.
The length of cable needed to make the "loop" is determined by measuring the
distance (L) between the two marks (A & B) and multiplying this by 3.
Make a loop from the calculated cable length and attach the cable fastener 20 mm
under the lower mark.
B
A
B
A
L
L
Use this procedure for both walker pads.
Lead the cable hereafter to the junction box. Lead the cable avoiding any sources
that might damage the cable and fasten the cable with the supplied fastener/cable
ties where possible to existing cables, hydraulic pipes, etc.
Connect the wires to the terminals as shown on the junction box PCB.