TeeJet 744E AUTO BOOM SECTION CONTROL - Manual (Page 7)

5
020-053-UK
TJ44E
sYsTEM ChECk
After connecting the power connector, it is time to make a system check. To check the
system, it is necessary to have full GPS signal. To obtain full GPS signal, the vehicle must
be placed outside.
Check AUTO mode:
TJ744E Switch box:
Section switches should be in the OFF position when working in Automatic mode. The
Master switch will control the sprayer and should be ON to enable automatic switching of
the sections.
Matrix:
• Turn the Guidance controller to ON
• Encode the number of sections and the width of each
(Refer to the Matrix user manual)
• Wait for GPS signal
• Set the mode to AUTO
• Drive forward (> 2 km/h)
• Observe that all valves open
• Check that the valves closes when the Master switch is set to OFF
Check MANUAL mode:
Matrix:
• Set the ABSC mode to MANUAL
• Check in the ‘Boom Section Control Screen’ (Matrix) that the section icons turn off
and on according to the valve/switch status
TJ744E Switch Box:
• Set the section switches to ON
• Set the Master switch to ON
• Observe that all valves are open
Figure 1-3: Matrix Boom Section Control Screen
km/h Hektar
0,0 6
km/h Hektar
1,2 6