TC-Helicon VoiceTone Synth Manual - Manual (Page 27)

27
I can’t hear any audio coming out of the
product
o Confirm you have power and a working mic by
singing through the mic and confirming that Input
LED flashes green, and sometimes orange.
o If Vocoder is turned on and set to Inst, there must
be audio coming from your instrument at the same
time you are vocalizing through the product.
o Confirm the Mono Out is connected to a PA.
I hear distortion
o Check the input LED, if it is flashing red, then turn
down the input volume.
o Is Transducer enabled? If so, the distortion may be
part of that style.
I can’t hear any effect
o Make sure the On LED is lit.
o Ensure that at least one of the three effects is
activate.
o If Vocoder is turned on, and Inst is selected, make
sure there is audio coming from you instrument.
Try turning up your instrument level if the problem
persists.
The effects sound out-of-tune
o Try using a fixed key and scale.
o Make sure your instrument/tracks are tuned to
A440.
o If you’re using Auto mode, turn up the level of the
instrument/source.
I’m using a Distortion style, but can’t hear it
o Raise your input level so the Input LED is flashing
orange.
My Instrument doesn’t seem to change the key
of the effects
o Confirm Auto key and scale is selected.
o Confirm Vocoder with a Synth sound is selected, or
HardTune is on.
o Remove any guitar effect pedals between your
FAQ and Troubleshooting