Front panel – TC-Helicon VoiceTone Synth Manual User Manual

Page 16

11.Transducer Button and LEDs

Press to select Transducer options or effect off.

12. LED Indicator Bar

This translucent bar indicates the status of the On
footswitch and lights the location of the Preset
footswitch. The Preset LED will flash on a Store
operation. Both LEDs flashing indicates Key Set mode.

13. Preset Select Footswitch

Tapping this footswitch will cycle forward through the 10
presets. Holding will store the current status of all effect
values to the current preset number.

14. On Footswitch

Use the On footswitch to toggle the current preset’s
effects on and off. If Tone is on, its effects remain active
whether the On button is lit or not.

You can hold the On footswitch to set the key for the
HardTune and Synth effects from a standing position.The
On and Preset LEDs will flash. VoiceTone Synth can
recognize simple major or minor chords played on an
instrument connected to the Inst input or you can tap
the On and Preset buttons to cycle through Key and
Major/Minor options respectively. Hold the On
footswitch to exit Key Set mode when you’re done.

Front Panel